A.yamaguchi
- Total activity 13
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 6
Articles
Recent activity by A.yamaguchi-
Which tablets have been used by customers?
Issue Which tablets have been used by customers? Answer 0人がフォロー質問下記端末となります。マニュアル3台ご利用実績のある端末一覧について、下記タブレットになります。 The following are the tablet list of devices that have been used in job site. ・Al...
-
How to display the cutting edge height as an elevation value
Introduction This article provides a detailed explanation on how to display the distance of the cutting edge to the design surface as an elevation value.In the section view, the cutting edge to the...
-
Error message "GNSS ERROR" is displayed.
Issue Smart Construction 3D Machine Guidance error display GNSS ERROR is displayed. Cause The reception of GNSS signal is weak. 3DMG construction is not possible. How to deal Are there ...
-
Error message "GNSS FIX NOT VALID" appears.
Issue Smart Construction Retrofit error message "GNSS FIX NOT VALID" is displayed. Cause The reception of GNSS signal is weak. 3DMG construction is not possible. There may be places ...
-
Error message "Boom head Pressure sensor error" is displayed.
Issue Error message "Boom head Pressure sensor error" is displayed. Cause The controller cannot detect the signal from the pressure sensor. How to deal By activating the debug mode, the pre...
-
Dump list does not appear on the tablet.
Issue Smart Construction 3D Machine Guidance does not display the dump list registered in the Smart Construction Fleet. Cause The main cause is that the basic information of Smart Construction...
-
App won't close on the tablet.
Issue When closing the application, it cannot close even after tapping "Clear All." Answer/Cause This is because the key symbol (hereinafter referred to as "app lock") is displayed in the upper r...