0.Introduction
Getting Started
Video of recommended operation for payload system
1.3DMG Machine (operator)
Project setting/function for working
How to set up the product data for work
How to offset the Design surface
How to create simple Design Surface in the app(３D data creation)
How to get and save the coordinate values of the cutting edge
Use projection
How to use projection for construction
Daily check
How to check the cutting edge accuracy
How to check the status of GNSS information
How to check the controller status
GNSS information reception settings
How to switch to Ntrip Caster (Base station)
How to switch to External Radio mode (base station)
Bucket setting
How to change the length of the worn out tooth
Display customize for work
How to use steer Indicator function
How to create the geofence data
How to use the 2D machine Guidance
How to customize the data display on guidance screen
How to change the screen split/layout
How to set up and use the compass function
How to display a heatmap of the construction history
How to display the bucket angle to design surface
How to extend a design surface
How to display the cutting edge height as an elevation value
Recommended settings for the tablet
Payload function for operator
How to set up for Payload Meter in a tablet
2.3DMG Machine(administrator)
Data transformation
How to perform bucket calibration
Payload function for administrator
How to manage the amount of soil to be hauled and the loading
3.Pilot web application(administrator)
Project setting
How to create the project for 3DMG machine
How to create and transfer data files for 3DMG machine
Geo-fence utilization
How to set up a restricted area within the jobsite using a geofence(PilotWEB-setup)
Data management function
How to check relation information of 3DMG on the web site
4.Solution Collaboration
3DMG machin
How to use 3DMG construction equipment at other companies' project sites.
Solution service
How to auto link 3DMG with Smart Construction Dashboard
5.Support function
Support function
Comments
1 comment
test
Article is closed for comments.