Daigo
- Total activity 75
- Last activity
- Member since
- Following 0 users
- Followed by 3 users
- Votes 2
- Subscriptions 39
Articles
Recent activity by Daigo-
How to switch to Komatsu Ntrip Caster (fixed station).
Introduction This article provides a detailed explanation on how to acquire correction information using the Ntrip distribution method. The antenna location information of base stations and 3DMG co...
-
How to switch External Radio mode (Fixed base station)
Introduction This article provides a detailed explanation on how to use of digital radio equipment to obtain correction information.Using digital radio equipment, the antenna location information o...
-
How to change the bucket data
Introduction This article provides a detailed explanation on how to change the bucket file on the guidance screen when the bucket in use is changed.By unifying the bucket and bucket file used, it i...
-
How to use Steer Indicator Function
Introduction This article provides a detailed explanation on how to display and construct a caution and horizontal distance based on the lines in the top view used by the 3DMG construction equipmen...
-
How to create the geofence data
Introduction This article provides a detailed explanation on how to create a geofence to freely set contact danger areas and deviation prevention areas with your 3DMG construction equipment.By sett...
-
How to use the ２D Machine Guidance.
Introduction This article provides a detailed explanation on how to generate a target surface from the posture of the vehicle body and construct it without using GNSS.This method is expected to be ...
-
How to customize the data display on the guidance screen.
Introduction This article provides a detailed explanation on how to customize the data display on the guidance screen.The operator can arbitrarily change the display format to whatever he/she wishe...
-
How to change the screen split/layout.
Introduction This article provides a detailed explanation on how to change the screen layout of the 3DMG construction machine used.The operator can arbitrarily change the viewpoints he/she wishes t...
-
How to set up and use the compass function.
Introduction This article provides a detailed explanation on how to check if the machine is facing the design surface.Using the compass display, you can ensure that you are facing the surface to be...
-
Inaccuracy of cutting edge
Issue The cutting edge deviates significantly from the benchmark coordinates when checking the accuracy of the cutting edge. (The difference from the control point is large in the cutting edge posi...