Daigo
- Total activity 75
- Last activity
- Member since
- Following 0 users
- Followed by 3 users
- Votes 2
- Subscriptions 37
Articles
Recent activity by Daigo-
How to use projection for construction
Introduction This article provides a detailed explanation on how to convert the location information acquired by 3DMG construction machine into coordinates (world geodetic system) for construction....
-
How to check the cutting edge accuracy
Introduction This article provides a detailed explanation on how to check the accuracy of the 3DMG construction machine by comparing the coordinate values of the cutting edge with the coordinate sy...
-
How to check the status of GNSS information
Introduction This article provides a detailed explanation on how to check the status of GNSS information acquired by 3DMG machine.By checking the status, you can confirm the number of satellites to...
-
How to check the controller status
Introduction This article provides a detailed explanation on how to check the controller status of the 3DMG machine used.By checking the status on a daily basis, you will be able to notice any prob...
-
How to switch to Komatsu Ntrip Caster (Base station)
Introduction This article provides a detailed explanation on how to acquire correction information using the Ntrip distribution method. The antenna location information of base stations and 3DMG co...
-
How to switch to External Radio mode (Fixed base station)
Introduction This article provides a detailed explanation on how to use of digital radio equipment to obtain correction information.Using digital radio equipment, the antenna location information o...
-
How to change the bucket data
Introduction This article provides a detailed explanation on how to change the bucket file on the guidance screen when the bucket in use is changed.By unifying the bucket and bucket file used, it i...
-
How to use Steer Indicator Function
Introduction This article provides a detailed explanation on how to display and construct a caution and horizontal distance based on the lines in the top view used by the 3DMG construction equipmen...
-
How to create the geofence data
- This article provides a detailed explanation on how to create a geofence to set dangerous contact areas and deviation prevention areas with your 3DMG construction equipment.- By setting up a geof...
-
How to use the ２D machine Guidance
Introduction This article provides a detailed explanation on how to generate a target surface from the posture of the vehicle body and construct it without using GNSS.This method is expected to be ...