Etsumi,s
- Total activity 9
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 4
Activity overview
Latest activity by Etsumi,s-
Etsumi,s created an article,
Error message "No machine calibration" is displayed.
Issue The error "No machine calibration" is displayed on the tablet. Cause There is a problem with the machine calibration information and the cutting edge coordinates cannot be calculated. H...
-
Etsumi,s created an article,
Controller firmware cannot be updated.
Issue Controller firmware update is not available. Cause Bluetooth and Location are ON in the tablet. How to deal Please turn off the Bluetooth and Location before update. * Bluetooth and Loca...
-
Etsumi,s created an article,
How to replace the tablet.
Issue How to replace the tablet of Smart Construction 3D Machine Guidance. How to deal 1) Set the Wi-Fi network connection of the new tablet to the target controller serial number "Retro- 48A...
-
Etsumi,s created an article,
The robot image appears on the tablet and cannot operate anything.
Issue An image of robot is on the tablet and cannot be operated. Answer/Cause The tablet has settings called "Fast boot Mode" or "FFBM Mode".If these mode are set, the display will be not operab...
-
Etsumi,s created an article,
How to know the SSID and password for Wi-Fi.
Issue How to know the SSID and password for Wi-Fi. Explanation 【"1"SSID】: The SERIAL NUMBER of the GNSS controller is the SSID. It is displayed on 【”1"the side of the controller.】Check 【”2"the se...