FAQ
- Quick troubleshooting list
- "Failed to get the cutting edge coordinates" is displayed.
- Error message "GNSS HEADING UNUSABLE" is displayed
- Inaccuracy of cutting edge
- Tablet goes to sleep by itself.
- Error message "No correction data" is displayed.
- Compass does not work (grayed out).
- Error message "Bucket is not selected" is displayed.
- How to create rpz project file for 3DMG?
- Error message "IMU Undetected" is displayed.
- The range of accuracy that can be ensured with the tilt bucket.
- The machine display doesn't match the actual machine movement
- Error message "Project file is not selected" is displayed
- Which tablets have been used by customers?
- What is the OSS (Open Source Software) used in controllers?
- File Transfer Issue for Machine with 3DMG
- How to check the status of the controller lamp.
- How to resolve error: "The license for Machine Guidance is not set."
- Design data cannot be converted. (Pilot WEB)
- Error message " Unconnected to controller" is displayed.
- Error message "Out of 3D design data range" is displayed.
- The picture of the machine on the tablet faces 180° in the opposite direction.
- Error message "No machine calibration" is displayed.
- Error message "GNSS antenna undetected" is displayed.
- Error message "Unable to calculate bucket angle" appears.
- Error message " ** AWAY FROM BASE STATION" is displayed.
- Error message "Localization error" is displayed.
- How to operate the excavator for payload calibration.
- How to change the display mode of the screen (change the view of guidance)
- Error message "GNSS ERROR" is displayed.